Fluke 9100 Series, User Handbook Manual

Page: 175 / 274

Section 10: Calibrating the Model 9100: Calibration Mode 10.2-1
Final Width = 215mm
10.2 The Model 9100 Calibration Mode
10.2.1 Introduction
This section is a guide to the use of the Model 9100's Calibration Mode. The following
topics are covered:
10.2.2 Mode Selection
10.2.2.1
'Mode' Key
10.2.2.2 'Mode Selection' Screen
10.2.3 Selection of Calibration Mode
10.2.3.1
Calibration Enable Switch
10.2.3.2 Password
10.2.3.3 Calibration Mode Display
10.2.3.4 Calibration Mode Screen Softkeys
10.2.4 Special Calibration
10.2.4.1
Selecting Special Calibration
10.2.4.2 The Characterise DAC Screen Display
10.2.4.3 Characterise DAC Errors
10.2.5 Cold Junction Calibration
10.2.5.1
Rationale
10.2.5.2 Selecting COLD JUNC CALIB
10.2.5.3 Entering Temperature Values
10.2.5.4 CJC Pod Identification
10.2.5.5 Equipment Requirements
10.2.5.6 Error Reduction
10.2.5.7 Cold Junction Calibration Procedure
10.2.6 Standard Calibration
10.2.6.1
Function Selection
10.2.6.2 Cal Mode Function Screens
10.2.6.3 Hardware Configurations
10.2.7 Overview of Calibration Operations