Feig Electronic ID ISC.LRU3000, Manual

Page: 38 / 193

OBID i-scan
®
UHF Manual ID ISC.LRU3000/3500
FEIG ELECTRONIC GmbH Page 38 of 193 H90202-7e-ID-B.docx
7.4. CFG3: RF-Interface
The parameters of the CFG3 configuration block contain global Transponder drivers and Reader
settings.
Byte 0 1 2 3 4 5 6
Contents
TAG-DRV
5
RF-POWER-
ANT1
REG 0x00 DC-Power 0x00
Default 0x0010 0x19
0x06
0x04
0x00 0x00
Byte 7 8 9 10 11 12 13
Contents 0x00 FREQ_US 0x00
NR_PREFER
RED_CHN
PREFERRED_CHN
Default 0x00 0x0000 0x00 0x00 0x0000
NOTE:
The settings in CFG3 are not affected by the command [0x8C] Reset
TAG-DRV
1
: (Transponder.Driver.UHF.Drivers
)
Defines the Transponder types that are operated by the Reader.
Byte 0 1
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Driver 0 0 0 0 0 0 0 0 0 0 0 E 0 0 0 0
b0: Driver for the Transponder type is inactive
b1: Driver for the Transponder type is active
.E: (Transponder.Driver.UHF.EPC_Class1Gen2) EPC class 1 Gen 2
In principle, only those Transponder drivers should be active that are used in the
actual application. Thus, the reaction time of the Reader for Transponder read- /
write-operations is reduced and the danger of a parasitic Transponder access is
minimized.
NOTE:
Except for the EPC GEN2 driver all other transponder drivers needs an upgrade code first.
The upgrade code must be ordered by your supplier or FEIG ELECTRONIC GmbH.
To operate an ISO 18000-6-C Transponder the EPC GEN2 driver needs to be enabled. This
Firmware Function needs to be activated with an upgrade code first.
5
A reasonableness check is performed by writing this parameter to the Reader. If an error occurs the Read-
er answers with STATUS = [0x11].