Feig Electronic ID ISC.LRU3000, Manual

Page: 143 / 193

OBID i-scan
®
UHF Manual ID ISC.LRU3000/3500
FEIG ELECTRONIC GmbH Page 143 of 193 H90202-7e-ID-B.docx
9.8. [0x72] Set Output
The command Set Output serves temporary limited or unlimited activation of the outputs of the
Reader.
Each output takes the state defined by the byte OUTx-mode for the period of time (OUT-TIME)
included in the protocol. The flashing frequency is defined by the byte OUTx-frq. Via this protocol
the outputs can be switched on or off for the indicated period of time. If the Reader receives a
command Set Output, all times that have been active until then are being overwritten by the new
times included in the protocol if they are
>
0.
Host
→
Reader
Byte 1 2 3 4 5
Contents n COM-ADR [0x72] Mode OUT-N

6 7 8-9 n-1...n

OUT-NR OUT-S OUT-TIME CRC16
Repeated OUT-N times
Host
←
Reader
Byte 1 2 3 4 5...6
Contents 6 COM-ADR [0x71]
STATUS
32
CRC16
Mode:
0x00
0x01 (reserved)
OUT-N:
Defines the number of output records.
32
see ANNEX C: Index of Status Bytes