Feig Electronic ID ISC.LRU3000, Manual

Page: 23 / 193

OBID i-scan
®
UHF Manual ID ISC.LRU3000/3500
FEIG ELECTRONIC GmbH Page 23 of 193 H90202-7e-ID-B.docx
While the EE-Init-Mode is active, the LED blinks alternately red and green and the Reader answers
external commands with the status "0x10 EEPROM Failure". The "EE-Init-Mode" can be exited
now by a new reset (cold start or
9.3. [0x64] System Reset command ). If after this the checksums
of all data records are correct, the Reader shifts to the configured operation mode.
NOTE:
Malfunctions may occur if parameters are configured outside their described range or if
unspecified parameters have been changed!
A downgrade of the firmware will result in a complete reset of the EEPROM. All parameters
will be reset to factory default.
Structure of configuration parameter description.
Byte 0 1 2 ......n
contents RAM-eff. EEPROM-
eff.
00
res
.....
not marked
Changing of this parame-
ter becomes immediately
effective after writing /
saving this configuration
block to RAM
marked with “00“
these bits or bytes are reserved for
future extensions or for internal
testing and manufacturing-
functions. These bits or bytes and
also any not described bits and
bytes
must not be changed , as
this may cause faulty operation of
the Reader.
gray marked
Changing of this parame-
ter only becomes effective
after writing / saving this
configuration block to
EEPROM and a reset of
the RF Controller with 9.3.
[0x64] System Reset in
mode 0x00.