Extreme Networks ExtremeWare 7.0.0, Command Reference Manual, Page: 997 / 1598

enable ospf export rip
ExtremeWare Software 7.0.0 Command Reference Guide 997
enable ospf export rip
enable ospf export rip [cost <metric> [ase-type-1 | ase-type-2] {tag
<number>} | <route map>]
Description
Enables the redistribution of RIP to OSPF.
Syntax Description
Default
The default tag number is 0. The default setting is disabled.
Usage Guidelines
After it is enabled, the OSPF router is considered to be an ASBR.
This command enables the exporting of RIP by way of LSA to other OSPF routers as AS-external type 1
or type 2 routes.
The cost metric is inserted for all BGP, VIP, RIP-learned, static, and direct routes injected into OSPF. The
tag value is used only by special routing applications. Use 0 if you do not have specific requirements
for using a tag. The tag value in this instance has no relationship with 802.1Q VLAN tagging.
When re-distributing RIP routes, you should turn off RIP aggregation unless you are expertly familiar
with the possible consequences and impact. By default, new configurations of RIP using ExtremeWare
4.0 and above disable RIP aggregation. In previous ExtremeWare versions, RIP aggregation is enabled
by default. This configuration is preserved when upgrading to ExtremeWare 4.0. Verify the
configuration using the command
show rip
.
Example
The following command enables the exporting of RIP to OSPF:
enable ospf export rip cost 1 ase-type-1 tag 0
History
This command was first available in ExtremeWare 4.0.
Platform Availability
This command is available on all platforms.
metric Specifies a cost metric.
ase-type-1 Specifies AS-external type 1 routes.
ase-type-2 Specifies AS-external type 2 routes.
number Specifies a tag value.
route map Specifies a route map name.