Extreme Networks ExtremeWare 7.0.0, Command Reference Manual, Page: 519 / 1598

config sys-health-check auto-recovery
ExtremeWare Software 7.0.0 Command Reference Guide 519
If the faulty module is a master MSM64i and there is no slave MSM64i, the system continues operation
in a “limited commands” mode. In the “limited commands” mode, the I/O slots are not initialized, and
only commands that do no affect the switch hardware configuration are allowed.
If the faulty module is a slave MSM64i, the fault is recorded in the slave’s MSM64i’s NVRAM and the
slave MSM64i is taken offline.
To view the failure messages, use the
show diag
command.
To clear the MSM64i failure messages posted to the log, use the
clear log diag-status
command.
This command will clear the error messages from the MSM64i NVRAM. If the MSM64i failed a system
health check, this command restores the MSM64i to full functionality. This command should only be
used for additional testing purposes and reproduction efforts of the original fault.
Example
The following command configures the system health checker to try ten times to bring a faulty MSM64i
back online:
config sys-health-check auto-recovery 10
History
This command was first available in ExtremeWare 6.1.9.
The system health check functionality was modified in ExtremeWare 6.2.1 to support packet memory
defect detection and mapping on selected I/O modules.
This command was modified in ExtremeWare 6.2.2 to support system health check and checksum error
checking on the BlackDiamond 6804 switch and to add the
online
and
offline
parameters.
Platform Availability
This command is available on the BlackDiamond switch only.
The packet-memory defect detection and mapping feature is supported only on selected I/O modules.
See the release note for your version of ExtremeWare for information on the supported modules.