Extreme Networks ExtremeWare 7.0.0, Command Reference Manual, Page: 673 / 1598

ssh2
ExtremeWare Software 7.0.0 Command Reference Guide 673
ssh2
ssh2 {cipher [3des | blowfish]} {port <portnum>} {compression [on | off]}
{user <username>} {debug <debug_level>} {<username>@} [<host> |
<ipaddress>] {<remote command>}
Description
Transmits a command to a remote system using an SSH2 connection.
Syntax Description
Default
N/A.
Usage Guidelines
You must be running a securtiy-enabled version of ExtremeWare 6.2.1 (which is under Export Control)
in order to use the SSH2 client command.
SSH2 does not need to be enabled on the switch in order to use this command. (SSH2 is enabled by
default if you are running a scurity-enabled version of ExtremeWare).
Typically this command is used to establish a secure session to a remote switch. You will be prompted
for your password. Once you have logged in successfully, all ExtremeWare commands you enter will be
exectued on the remote switch. When you terminate the remote session, commands will then resume
being executed on the original switch.
The remote command option cannot be used with Extreme Networks switches. If you include a remote
command, you will receive an error message.
3des Specifies that the 3des cipher should be used for encryption. This is the
default.
blowfish Specifies that the blowfish cipher should be used for encryption.
portnum Specifies the TCP port number to be used for communicating with the SSH2
client. Default is port 22.
compression
on
specifies that data is to be compressed.
off
specifies that compression is not to be used. Default is
off
.
username Specifies a login name for the remote host, as an alternate to the user@host
parameter.
debug_level Specifes a debug level. Default is 0
username Specifies a login name for the remote host. May be omitted if it is the same as
the username on the switch.
host Specifies the name of the remote host
ipaddress Specifies the IP address of the remote host
remote command Specifes a command to be passed to the remote system for execution.
Remote commands are not supported on switches. This option is only valid if
the remote system is a system, such as a UNIX workstation, that can accept
remote commands.