Emerson MICRO MOTION 2700, Configuration And Use Manual, Page: 227 / 374

Status alarms and recommended actions
(continued)
Table 12-2:
Alarm code Description Recommended actions
A117 Density Overrange (Petrole-
um) 1. Check your process conditions against the values reported
by the flowmeter.
2. Verify the configuration of the petroleum measurement ta-
ble type and density.
A118 Discrete Output 1 Fixed The discrete output has been configured to send a constant val-
ue.
A120 Curve Fit Failure (Concentra-
tion) Verify the configuration of the concentration measurement ap-
plication.
A121 Extrapolation Alarm (Concen-
tration) If the product in the sensor has temperature or density proper-
ties that are outside the parameters established by the concen-
tration measurement curve, this is a symptom and no action is
required. This alarm should clear when the process fluid returns
to normal.
If the problem persists, check the configuration of the concen-
tration measurement application.
A131 Meter Verification in Progress:
Outputs to Last Measured Val-
ue Meter verification in progress, with outputs set to
Last Measured
Value
.
A132 Sensor Simulation Active Simulation mode is enabled.
A133 EEPROM Error (Display) Change the display module. If the problem persists, contact
Micro Motion.
A141 DDC trigger(s) have comple-
ted No action required.
N/A Density FD Calibration in Pro-
gress No action required.
N/A Density D1 Calibration in Pro-
gress No action required.
N/A Density D2 Calibration in Pro-
gress No action required.
N/A Density D3 Calibration in Pro-
gress No action required.
N/A Density D4 Calibration in Pro-
gress No action required.
N/A Zero Calibration in Progress No action required.
N/A Reverse Flow No action required.
Troubleshooting
Configuration and Use Manual 219