Eaton Rapid Link RAMO5, Manual

Page: 151 / 218

6 RASP5 Speed controller
6.7 Configure special settings
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
147
6.7.3 Phase change
For RASP5, parameter P6-08 changes the rotary field at the output from
FWD to REV. The control logic and the LED signals stay in the FWD function.
6.7.4 Stop behavior
RASP5 units do not require an external 24 VDC control voltage.
However, with their AS interface connection, RASP5 can be used to deceler-
ate the motor to a controlled stop in the event that the connection’s external
24 V DC voltage drops out with the second ramp (P2-13). To do this, the
24 V DC voltage must be supplied via the AS-interface connection
M12.
￫
Parameters should only be changed by expert users as specified
in the manual.
Para-
meter Designation Description Unit Min Max DS
P6-08 Change Phase sequence
Motor Changes the sequence of the output phases.
This prevents, that two phases of the motor cable have to be
changed in case the motor runs in the wrong direction.
0: U, V, W (cw)
1: U, W, V (ccw)
– 0 1 0
Para-
meter Designation Description Unit Min Max DS
P3-11 t-dec Select B0 Deceleration Ramp Select Bit 0
External stop function:
0: deactivated
1: Enabled
– 0 1 0