Eaton Rapid Link RAMO5, Manual

Page: 166 / 218

10 Parameter list
10.2 Menu structure
162
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
10.2 Menu structure
The following tables use a number of acronyms. These acronyms are defined
below:
10.3 Parameter groups for RAMO
10.3.1 “Monitor” parameter group 0
Abbreviation Meaning
DS Default setting (the parameter's value when using the device's
factory settings)
￫
None of the parameters in parameter group 0 can be modified
by the user, i.e., they are read-only parameters.
Parameter Designation Description Unit
P0-02 Thermistor Input1 Thermistor Status
0: Motor temperature ok
1: Motor temperature too high %
P0-03 DI Status Status of the Sensor Inputs and ASI Pin 4
P0-05 T-Controlboard Internal ambient temperature of the device, measured
on the control board %
P0-06 Overload Calculated overload in % above the currentlevel set
with P1-08. If the value rises to 100 %, the device will
trip with error message
I.t-trP
.
Hz/rpm
P0-07 Output Frequency Instantaneous output frequency A
P0-09 Motor Current Instantaneous output current kW
P0-10 Motor Power Rel Motor Power (actual value) in kW/HP
P0-13 Trip Log Display of the 4 latest faults V
P0-17 HOA Status Key switch status
1 hand
2: auto MWh
P0-18 FWD/REV Status Selector switch status FWD / REV
1: FWD
2: REV
P0-19 DO 1 to 3 Status Status of the actuators
P0-20 DC-Link Voltage Instantaneous DC Link Voltage
Display 600 = 600 V V
P0-22 TimeToNextService Time remaining to next service
The service interval is set with P2-28. Hours
P0-24 t-Run PCB in OT Time elapsed, in which the drive has operated with a
high temperature at the PCBs (ambient temperature).
Displays the time in hours and minutes above 80 °C.
The value is used for various internal protective func-
tions. hh:mm:ss