Eaton Rapid Link RAMO5, Manual

Page: 182 / 218

10 Parameter list
10.4 Parameter groups for RASP
178
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
10.4.3 Parameter group 2 (“Extended functions”)
Table 36: Parameter group 2 (“Extended functions”)
Para-
meter Designation Description Unit Min Max DS
P2-01 f-Fix2 Preset Fixed Frequency 2
Value can be adjusted between f-min and f-max. Selection
via a digital control signal. Hz/rpm P1-02 P1-01 30 Hz
P2-02 f-Fix3 Preset Fixed Frequency 3
Value can be adjusted between f-min and f-max. Selection
via a digital control signal. Hz/rpm P1-02 P1-01 40 Hz
P2-03 f-Fix4 Preset Fixed Frequency 4
Value can be adjusted between f-min and f-max. Selection
via a digital control signal. Hz/rpm P1-02 P1-01 50 Hz
P2-04 f-Fix5 Preset Fixed Frequency 5
Value can be adjusted between f-min and f-max. Selection
via a digital control signal. Hz/rpm P1-02 P1-01 10 Hz
P2-05 f-Fix6 Preset Fixed Frequency 6
Value can be adjusted between f-min and f-max. Selection
via a digital control signal. Hz/rpm P1-02 P1-01 15 Hz
P2-06 f-Fix7 Preset Fixed Frequency 7
Value can be adjusted between f-min and f-max. Selection
via a digital control signal. Hz/rpm P1-02 P1-01 20 Hz
P2-07 f-Fix8 Preset Fixed Frequency 8
Value can be adjusted between f-min and f-max. Selection
via a digital control signal. Hz/rpm P1-02 P1-01 25 Hz
P2-08 t-SRamp1 Curve shape, temporal S-shape
Linear acceleration and deceleration time according to P1-
03 and P1-04.
Timed slured Transition to Start and End of Acceleration
(P1-03) and Deceleration Ramps (P1-04).
The time set here applies to both ramps. 0.0 = linear. s 0 10 0
P2-09 Overvoltage Control The over voltage control prevents the drive from tripping in
case of regenerative energy feedback from the motor to
the DC link. When disabled, the drive will trip “Over
Voltage” instead of automatically increasing the motor
ramp times. - 0 1 1
P2-10 REV Enable Activates or deactivates reverse rotation of the motor
0: REV activated - motor is running forward and revers
1: REV deactivated - motor is only forward - 0 1 0
P2-11 t-acc2 Sets the acceleration ramp time 2 in seconds. s 0 3000 5.0
P2-12 n-accMulti1 Frequency / speed, at which the acceleration ramp
changes from t-acc1 to t-acc2.
This can be set to any value between 0 and “f-max” (P1-01)
“Motor Nom Speed” (P1-10) = 0, displayed in Hz.
”Motor Nom Speed” (P1-10) > 0, displayed in rpm.
Frequency/Speed > P2-12 = t-acc2
Frequency/Speed < P2-12 = t-acc1 Hz/rpm 0 P1-01 0
P2-13 t-dec2 Sets the deceleration ramp time 2 in seconds.
Activation via pin 4 at AS-i. s 0 3000 5.0