Eaton Rapid Link RAMO5, Manual

Page: 145 / 218

6 RASP5 Speed controller
6.6 LED Indicators
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
141
Figure 94: RASP5 Block diagram
a RASP5-…-xxxR…
b RASP5-xx1… (180 V DC)
RASP5-xx2… (230/277 V AC)
RASP5-xx4… (400/480 V AC)
c RASP5-…-xxxxxx1xx (FAN)
d RASP5-…-xxx1...
e RASP5-…-xxxxx1xxx (STO)
6.6 LED Indicators
The LEDs indicators of motor control unit RASP5 display the operating states
and allow a quick diagnosis.
LED Display Description
FWD Clockwise rotating field of motor voltage (U-V-W)
Off Not actuated
Green enabled (RUN-Mode)
Flashing
(green) controlled:
• but inhibited through quick stop function of sensor inputs
• but inhibited because the key switch was in position MANUAL when
the supply voltage
(400 V or AS interface) was switched on.
￫ Reset order required.
• STO signal present (inhibit)
REV Counterclockwise rotating field of motor voltage (W-V-U)
Off Not actuated
Green enabled (RUN-Mode)
Flashing
(green) controlled:
• but inhibited through quick stop function of sensor inputs
• but inhibited because the key-operated switch was in the MANUAL
position when the supply voltage(400 V or AS-i) was switched on.
￫ Reset order required
• STO signal present (inhibit)
AS interface
Off No supply voltage in the AS-i electronics:
￫ Check AS interface connection cables
￫ Check AS interface power supply unit (master control)
Green Communication active, normal operation
Red
Green Flashing No communication:
• RASP5 not entered or entered with the wrong address (ID).
Flashing
Green/Red AS interface address = 0:
￫ AS interface setting the address
Green
Red flashing ￫ fatal peripheral error; internal ASi error
I1 Sensor input I1
Off • not connected
• Not triggered (no input signal)
Green SI1 triggered (input signal)
REV OFF FWD
PWR FLT
AS-I
Data
Fault
OFF/RESET
SEN I1/I3
I1
SEN I2/I4
I2
I3
I4
STO
FAN