Eaton Rapid Link RAMO5, Manual

Page: 162 / 218

9 Control Unit
9.2 Extended parameter set
158
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
9.1.2 Resetting Parameters (RESET)
Table 25: Resetting parameters (RESET)
9.2 Extended parameter set
Table 26: Enabling and disabling access to the extended parameter set
Command Description
Reset to default settings
+ +
Press the
▲
and
▼
and STOP buttons and hold them down for two seconds.
-> All parameters will be restored to their default settings.
The display will show
P-dEF
.
Resetting after a fault
Press the STOP button to reset a fault message.
The display will show
StoP
.
Commands Description
Enabling access to the extended parameter set
Press the OK button and hold it down for two seconds in order to
access the parameter interface.
->
The display will show the parameter that was last used.
Use the
▲
and
▼
buttons to select parameter P1-14.
Press the OK button.
Use
▲
or
▼
- to select the password set with parameter P2-40
(Level 2, default setting 101).
Press the OK button to confirm.
-> The extended parameter set will now be available.
Disabling access to the extended parameter set
Use the
▲
and
▼
buttons to set a value for P1-14 that does not match
the password (P2-32).
Press the OK button to confirm.
-> Only the “basic parameters,” i. e., the parameters in the first param-
eter group (P1-01 to P1-14), will be accessible now.