Eaton Rapid Link RAMO5, Manual

Page: 129 / 218

5 RAMO5 Motor starter
5.6 LED displays
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
125
5.6 LED displays
The LEDs of motor control unit RAMO5 indicate the operating states and
allow a quick diagnosis.
LED State Description
FWD Clockwise rotating field of motor voltage (U-V-W)
Off Not actuated
Green enabled (RUN mode)
Flashing
(green) controlled:
• but inhibited through quick stop function of sensor inputs I1 and I2)
• but inhibited because the key-operated switch was in the MANUAL
position when the supply voltage
￫ A Reset command required.
REV Counterclockwise rotating field of motor voltage (W-V-U)
Only for reversing starters!
Off Not actuated
Green enabled (RUN mode)
Flashing
(green) controlled:
• but inhibited through quick stop function of sensor inputs I1 and I2
• but inhibited because the key-operated switch was in the MANUAL
position when the supply voltage
￫ A Reset command required.
AS-Interface
Off AS-Interface electronics have no supply voltage:
Check AS interface connection cables
Check AS interface power supply unit (head-end controller)
Green Communication active, normal operation
Red
Green
flashing No communication:
• Head-end controller (master) in STOP mode.
• RAMO5 not entered or entered with the wrong address (ID).
• RAMO5 in Reset mode.
Flashing
Green/Red AS-i address = 0
￫ AS interface setting the address
Green
Red flashing fatal peripheral error, internal ASi error
I1 Sensor input I1
Off • not connected
• Not triggered (no input signal)
Green I1 triggered (input signal)
REV OFF FWD
PWR FLT
SEN I1
I1
ACT Q1
Q1
SEN I2
I2
AS-I
Data
Fault
OFF/RESET