Eaton Rapid Link RAMO5, Manual

Page: 198 / 218

11 Communications
11.2 ASI flat cable
194
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
11.1.7 Replacing Rapid Link devices in the AS-i circuit
If a slave fails due to a fault, it can be replaced with an identical device with
an address of 0. The gateway will detect the replacement and will automati-
cally reassign the faulty slave’s address to the new slave. It may be neces-
sary to configure this feature on the gateway.
If the replacement device does not have a default address of 0, it will be
necessary to program it with the faulty device’s address.
11.2 ASI flat cable
You can fit M12 branches (ZB2-100-AZ1) at any point along the AS-Interface
ribbon cable.
Both the mechanical and electrical connections are carried out in one opera-
tion:
▶ Release the black union nut until the contact tips no longer protrude.
▶ Insert the two-wire profile ribbon cable and clip the junction shut.
▶ Retighten the black union nut.
The device or module is now ready for operation.
Figure 109: Junction M12 (order no.: ZB2-100-AZ1)
The Rapid Link function modules have an AS-Interface M12 plug-in connec-
tor that fits the M12 junction.
￫
You can use the AS-i gateway to delete the existing Rapid Link
address and assign a new address.
￫
For detailed information on addressing and troubleshooting the
gateway , refer to the manufacturer’s manual.
Pin Function
1 AS-In
2 0 V
3 AS-Interface -
4 +24 V DC
5 –