Eaton Rapid Link RAMO5, Manual

Page: 130 / 218

5 RAMO5 Motor starter
5.6 LED displays
126
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
I2 Sensor input SI2
Off • not connected
• Not triggered (no input signal)
Green SI2 triggered (input signal)
Q1 Actuator output Q1
Only for RAMO5-xx1… !
Off • Not actuated
Green Q1 triggered (output signal)
Note:
If the external supply voltage for Q1 (24 V DC)
is missing, no signal is applied at the output.
PWR Off The 400 V supply voltage is missing or the repair switch is switched off.
Green Supply voltage 400 V
RAMO group fault indication
Off No fault message
FLT Red Fault message:
An error has been detected and is permanently present - in the case of:
• Motor overload (overcurrent)
￫ Check motor and drive unit
(reset with engine cooled down) ≥ parameters
￫ Check short shot in motor lead
￫ parameters
• Thermistor/cable monitoring
￫ Check motor and drive unit
(reset when motor has cooled down)
￫ No motor cable connected (motor outgoer socket)
￫ Wire jumper not closed with motor cable disconnected
( ￫ for servicing only)
• Overload/short circuit on sensor inputs or actuator output
On a temporary or rectified fault this LED flashes until the Reset command is
issued.
Flashing
(red) The detected fault (the fault signal's cause) has been fixed.
The fault signal can now be acknowledged with key switch OFF/RESET
(
￫ The LED FLT goes out).
LED State Description
REV OFF FWD
PWR FLT
SEN I1
I1
ACT Q1
Q1
SEN I2
I2
AS-I
Data
Fault
OFF/RESET