Eaton Rapid Link RAMO5, Manual

Page: 167 / 218

10 Parameter list
10.3 Parameter groups for RAMO
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
163
P0-26 kWh Meter Energy Consumption kWh Meter (not resettable)
Displays the energy consumption in kWh. When the
value reaches 1000, it is reset back to 0 and the number
of MWh in P0-27 is increased by 1. The value cannot be
reset and shows together with P0-27 the energy
consumption since the day of manufacture. kWh
P0-27 MWh Meter Energy Consumption MWh Meter (not resettable)
Displays the energy consumption in MWh. The value
cannot be reset and shows together with P0-26 the
energy consumption since the day of manufacture. MWh
P0-28 Application Version Application Version
Level 1: Application v Check sum
Level 2: System v Check sum
P0-28 System Version System Version
P0-29 n/a Device Information
P0-29 NoOfInputPhases Number of input phases
P0-29 FrameSize Frame Size
P0-29 kW/HP Motor Power
P0-29 Power@Ue Device Power at Device Voltage Rating
P0-29 Device Voltage Device Voltage Rating
P0-29 DeviceType Device Type
P0-30 Serial Number Serial Number of the device (don’t use for new devices)
P0-31 t-Run Total operating time of the drive since the date of manu-
facture
Displayed in hours, minutes and seconds. Pressing the
UP key on the drive keypad will change the display from
“hours” to “minutes and seconds”. hh:mm:ss
P0-32 t-Run since Restart Run time since power on or last Reset
Total operating time of the drive since the last trip
occured or power down in hours, minutes and seconds.
Pressing the UP key on the drive keypad will change the
display from “hours” to “minutes and seconds”. hh:mm:ss
P0-33 t-Run since Trip Total operating time of the drive since the last trip
occurred
Displayed in hours, minutes and seconds. Pressing the
UP key on the drive keypad will change the display from
“hours” to “minutes and seconds”. hh:mm:ss
P0-34 t-HoursRun Enable Total operating time of the drive since the last drive
ENABLE signal was applied.
Displayed in hours, minutes and seconds. Pressing the
UP key on the drive keypad will change the display from
“hours” to “minutes and seconds”. hh:mm:ss
P0-36 DC-Link Log DC link voltage log
Displays the most recent 8 samples of the DC bus
voltage prior to a drive trip condition occurring.
The sample interval is 256 ms. V
P0-37 DC-Link V-Ripple Log DC bus Voltage Ripple Log
Displays the most recent 8 samples of the ripple of the
DC bus voltage prior to a drive trip condition occurring.
The sample interval is 20 ms.
Parameter Designation Description Unit