DEUTZ-FAHR FL35-70HP Series, Operation Manual

Page: 222 / 417

Electrical system
221
Rotate bolt of regulator in the figure (
①
or
②
) to move
vertical or horizontal light beam. Where:
Bolt
①
of the regulator is used to move light beam at the
vertical direction.
Bolt
②
of the regulator is used to move light beam at the
horizontal direction.
Fig. 6-20
Warning:
In order to determine the points on the wall corresponding to the centers of the headlights, bring the
tractor up to the wall with the dipped headlights on, mark the centers
①
on the wall and then reverse
to a distance of 10 m from the wall.
Horizontal adjustment of head light
With the headlights switched on, the centers of the beams should be apart the distance A indicated in the figure.
Vertical adjustment of head light
With the headlights on, the lines delimiting the light and dark zones on the wall should be 10 cm apart as shown in
the figure by (h).
6.4.Worklights
6.4.1.Worklights
Important:
Avoid touching the inner surface of the reflector. Make sure no foreign material gets inside the
reflector.
6.4.2.
The tractor will be equipped with the following Worklights: