DEUTZ-FAHR FL35-70HP Series, Operation Manual

Page: 204 / 417

Electrical system
203
●
Integral type;
●
Wheel metal disc;
Methods for installing different ballast
➢
Cast iron "box-shaped" blocks
This kind of ballast can be installed by one worker. The ballast shall be placed on the front bracket for installation.
Danger:
Please make sure to check the weight of each ballast. If it weighs more than the bearable limit (male: 30
kg, female: 20 kg), please use appropriate mechanical lifting devices.
➢
Bolted cast iron pieces
Such ballast must be installed by at least two workers – One undertakes to lift the ballast up in place while the other
uses bolts to fix the ballast.
Danger:
Please make sure to check the weight of each ballast. If it weighs more than the bearable limit (male: 30
kg, female: 20 kg), please use appropriate mechanical lifting devices.
➢
Intermediate plate
The intermediate plate must be installed by at least two workers – One undertakes to lift up in place while the other
uses bolts to fix the load block.
Danger:
Please make sure to check the weight of each load. If it weighs more than the bearable limit (male: 30
kg, female: 20 kg), please use appropriate mechanical lifting devices.
➢
Ballast block
Each ballast block must be installed by at least two workers, with the specific operation steps as follows:
●
Lower the front lift arm;
●
Drive the tractor forward slowly to the ballast;
●
Raise the lift arm until the hooked hanger has engaged with the lateral positioning pin;
●
Use pins to connect the upper link and the huge rock.