DEUTZ-FAHR FL35-70HP Series, Operation Manual

Page: 210 / 417

Electrical system
209
Warning:
Always disconnect the battery before carrying out any work on the electrical system. Disconnect the
battery and all the Electronic Control Units whenever it is necessary to do any welding on the tractor
or any of the equipment connected to the tractor.
Danger:
The gases given off by the battery are highly explosive. Never cause a spark or allow a naked flame
near the battery. Batteries must be stored and charged in a well-ventilated environment. Take care
that the acid electrolyte does not come into contact with your skin or clothes.
To remove the battery, proceed as follows:
● Disconnect connection
②
between ground
terminal and negative terminal;
● Disconnect the power supply wire
①
from the
positive terminal;
● Completely loosen and remove nut and gaskets
③④⑤
;
● Remove pressing plate
⑥
of the storage battery
● Remove the battery
⑦
from the holder;
To refit the battery, proceed as follows:
● Install battery
⑦
from the holder:
● Install pressing plate
⑥
of the storage battery;
● Install and tighten nuts and gaskets
③④⑤
;
● Connect the power supply wire
①
from the
positive terminal;
● Connect connection
②
between the ground
terminal and negative terminal.
Fig. 6-2