DEUTZ-FAHR FL35-70HP Series, Operation Manual

Page: 160 / 417

Electrical system
159
Notice:
When the tractor is not connected with the implement, the control handle should be in neutral
position.
Important:
When an implement with a power take-off is required, it is required that the implement be at a height
above the ground to ensure no influence on steering of the tractor in the field, for the purpose of
preventing damage to the implement, due to excessive lifting height resulting in a bigger angle
between the PTO shaft and the drive shaft of the implement.
4.11.Three-point Linkage
FL35-70HP Series tractors adopt a rear three-point linkage to connect the implement.
Notice:
Hooking on to the rear axle or any other point above the swinging drawbar or rear wheels can cause the
tractor to tip over.
Notice:
When working with the 3-point linkage, ensure that anybody keeps far away from working radius of the
lifting arm and any attached implement. This is to avoid personal injury in case of mis-operation.
Warning:
Always check that the weight of the implement is compatible with the maximum permissible load on the
tractor axles.