Dell S4820T, Configuration Manual

Page: 454 / 1178

CONFIGURATION mode
interface range macro name
Example of Using a Macro to Change the Interface Range Configuration Mode
The following example shows how to change to the interface-range configuration mode using the
interface-range macro named “test.”
Dell(config)# interface range macro test
Dell(config-if)#
Monitoring and Maintaining Interfaces
Monitor interface statistics with the
monitor interface
command. This command displays an ongoing
list of the interface status (up/down), number of packets, traffic statistics, and so on.
To view the interface’s statistics, use the following command.
• View the interface’s statistics.
EXEC Privilege mode
Enter the type of interface and slot/port information:
– For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port
information.
– For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
– For the Management interface on the stack-unit, enter the keyword
ManagementEthernet
then
the slot/port information. The slot range is from 0 to 1. The port range is 0.
Example of the
monitor interface
Command
The information displays in a continuous run, refreshing every 2 seconds by default. To manage the
output, use the following keys.
•
m
— Change mode
•
l
— Page up
•
T
— Increase refresh interval (by 1 second)
•
t
— Decrease refresh interval (by 1 second)
•
c
— Clear screen
•
a
— Page down
•
q
— Quit
Dell#monitor interface Te 3/1
Dell uptime is 1 day(s), 4 hour(s), 31 minute(s)
Monitor time: 00:00:00 Refresh Intvl.: 2s
Interface: Te 3/1, Disabled, Link is Down, Linespeed is 1000 Mbit
Traffic statistics: Current Rate Delta
Input bytes: 0 0 Bps 0
Output bytes: 0 0 Bps 0
Input packets: 0 0 pps 0
Output packets: 0 0 pps 0
454
Interfaces