Dell S4820T, Configuration Manual

Page: 356 / 1178

• Enable IPv6 Deterministic ECMP next hop.
CONFIGURATION mode.
ipv6 ecmp-deterministic
Configuring the Hash Algorithm Seed
Deterministic ECMP sorts ECMPs in order even though RTM provides them in a random order. However,
the hash algorithm uses as a seed the lower 12 bits of the chassis MAC, which yields a different hash
result for every chassis.
This behavior means that for a given flow, even though the prefixes are sorted, two unrelated chassis can
select different hops.
Dell Networking OS provides a command line interface (CLI)-based solution for modifying the hash seed
to ensure that on each configured system, the ECMP selection is same. When configured, the same seed
is set for ECMP, LAG, and NH, and is used for incoming traffic only.
NOTE: While the seed is stored separately on each port-pipe, the same seed is used across all
CAMs.
NOTE: You cannot separate LAG and ECMP, but you can use different algorithms across the chassis
with the same seed. If LAG member ports span multiple port-pipes and line cards, to achieve
deterministic behavior, set the seed to the same value on each port-pipe.
NOTE: If you remove the hash algorithm configuration, the hash seed does not return to the
original factory default setting.
To configure the hash algorithm seed, use the following command.
• Specify the hash algorithm seed.
CONFIGURATION mode.
hash-algorithm seed value [stack—unit number ] [port-set number ]
The range is from 0 to 4095.
Link Bundle Monitoring
Monitoring linked ECMP bundles allows traffic distribution amounts in a link to be monitored for unfair
distribution at any given time. A default threshold of 60% is defined as an acceptable amount of traffic on
a member link. Links are monitored in 15-second intervals for three consecutive instances. Any deviation
within that time causes a syslog to be sent and an alarm event generate. When the deviation clears,
another syslog is sent and a clear alarm event generates. For example, link bundle monitoring percent
threshold:
%STKUNIT0-M:CP %IFMGR-5-BUNDLE_UNEVEN_DISTRIBUTION: Found uneven
distribution in LAG bundle 11.
Link bundle utilization is calculated as the total bandwidth of all links divided by the total bytes-per-
second of all links. Within each ECMP group, you can specify interfaces. If you enable monitoring for the
ECMP group, utilization calculation performs when the utilization of the link-bundle (not a link within a
bundle) exceeds 60%.
356
Equal Cost Multi-Path (ECMP)