• Set the RIP versions received on that interface.
INTERFACE mode
ip rip receive version [1] [2]
• Set the RIP versions sent out on that interface.
INTERFACE mode
ip rip send version [1] [2]
Examples of the RIP Process
To see whether the
version
command is configured, use the
show config
command in ROUTER RIP
mode.
The following example shows the RIP configuration after the
ROUTER RIP mode version
command is
set to RIPv2. When you set the
ROUTER RIP mode version
command, the interface
(
TenGigabitEthernet 1/1
) participating in the RIP process is also set to send and receive RIPv2
(shown in bold).
To view the routing protocols configuration, use the
show ip protocols
command in EXEC mode.
Dell#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 23
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control:
receive version 2, send version 2
Interface Recv Send
TenGigabitEthernet 1/1 2 2
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway Distance Last Update
Distance: (default is 120)
Dell#
To configure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax.
The command syntax for sending both RIPv1 and RIPv2 and receiving only RIPv2 is shown in the
following example.
Dell(conf-if)#ip rip send version 1 2
Dell(conf-if)#ip rip receive version 2
The following example of the
show ip protocols
command confirms that both versions are sent out
that interface. This interface no longer sends and receives the same RIP versions as Dell Networking OS
does globally (shown in bold).
Dell#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 11
Invalid after 180 seconds, hold down 180, flushed after 240
830
Routing Information Protocol (RIP)
Summary of Contents for S4820T
