Dell S4820T, Configuration Manual

Page: 964 / 1178

NOTE: The device does not require special stacking cables. The cables used to connect the
data ports are sufficient.
7. Reload the stack one unit at a time.
EXEC Privilege mode
show system brief
Start with the management unit, then the standby, then each of the members in order of their
assigned stack number (or the position in the stack you want each unit to take).
Allow each unit to completely boot, and verify that the stack manager detects the unit, then power
the next unit.
Example of a Syslog
Figure 119. Creating a New Stack
In the following example, stack unit is the master management unit, stack unit 2is the standby unit. The
cables are connected to each unit.
Configure the stack groups on the units in the following order:
• Configure the first stack group on unit 1:
stack-unit 1 stack-group 13
• Configure the stack groups on unit 2:
stack-unit 2 stack-group 14
and
stack-unit 2
stack-group 15
• Configure the stack groups on unit 3:
stack-unit 3 stack-group 12
and
stack-unit 3
stack-group 13
• Configure the stack groups on unit 4:
stack-unit 4 stack-group 13
and
stack-unit 4
stack-group 31
• Configure the final stack-group on unit 1 to complete the stack:
stack-unit 1 stack-group 31
When the stack-group configuration is complete, the system prints a syslog for reload.
Dell#configure
Dell(conf)#stack-unit 4 stack-group 13
Dell(conf)#02:39:12: %STKUNIT4-M:CP %IFMGR-6-STACK_PORTS_ADDED: Ports Fo 4/52
have been configured as
stacking ports. Please save and reload for config to take effect
Dell(conf)#stack-unit 4 stack-group 14
Dell(conf)#02:39:15: %STKUNIT4-M:CP %IFMGR-6-STACK_PORTS_ADDED: Ports Fo 4/56
have been configured as
964
Stacking