Dell S4820T, Configuration Manual

Page: 62 / 1178

For a particular target where VRF is enabled, the show output is similar to the following:
Feature State
------------------------------
VRF enabled
View Command History
The command-history trace feature captures all commands entered by all users of the system with a time
stamp and writes these messages to a dedicated trace log buffer.
The system generates a trace message for each executed command. No password information is saved
to the file.
To view the command-history trace, use the
show command-history
command.
Example of the
show command-history
Command
Dell#show command-history
[12/5 10:57:8]: CMD-(CLI):service password-encryption
[12/5 10:57:12]: CMD-(CLI):hostname Force10
[12/5 10:57:12]: CMD-(CLI):ip telnet server enable
[12/5 10:57:12]: CMD-(CLI):line console 0
[12/5 10:57:12]: CMD-(CLI):line vty 0 9
[12/5 10:57:13]: CMD-(CLI):boot system rpm0 primary flash://FTOS-
CB-1.1.1.2E2.bin
Upgrading Dell Networking OS
NOTE: To upgrade Dell Networking Operating System (OS), refer to the Release Notes for the
version you want to load on the system.
Using HTTP for File Transfers
Stating with Release 9.3(0.1), you can use HTTP to copy files or configuration details to a remote server.
Use the copy source-file-url http://host[:port]/file-path command to transfer files to an external server.
Enter the following source-file-url keywords and information:
• To copy a file from the internal FLASH, enter flash:// followed by the filename.
• To copy the running configuration, enter the keyword running-config.
• To copy the startup configuration, enter the keyword startup-config.
• To copy a file on the external FLASH, enter usbflash:// followed by the filename.
In the Dell Networking OS release 9.8(0.0), HTTP services are enhanced to support the VRF-aware
functionality. If you want the HTTP server to use a VRF table that is attached to an interface, configure
that HTTP server to use a specific routing table. You can use the
ip http vrf
command to inform the
HTTP server to use a specific routing table. After you configure this setting, the VRF table is used to look
up the destination address.
62
Getting Started