Dell S4820T, Configuration Manual

Page: 539 / 1178

ip address ip-address mask
Assign an IP address and mask to the interface.
The IP address must be on the same subnet as other IS-IS neighbors, but the IP address does not
need to relate to the NET address.
5. Enter an IPv6 Address.
INTERFACE mode
ipv6 address ipv6-address mask
•
ipv6 address
: x:x:x:x::x
•
mask
: The prefix length is from 0 to 128.
The IPv6 address must be on the same subnet as other IS-IS neighbors, but the IP address does not
need to relate to the NET address.
6. Enable IS-IS on the IPv4 interface.
ROUTER ISIS mode
ip router isis [ tag ]
If you configure a tag variable, it must be the same as the
tag
variable assigned in step 1.
7. Enable IS-IS on the IPv6 interface.
ROUTER ISIS mode
ipv6 router isis [ tag ]
If you configure a tag variable, it must be the same as the
tag
variable assigned in step 1.
Examples of the
show isis
Commands
The default IS type is level-1-2 . To change the IS type to Level 1 only or Level 2 only, use the
is-type
command in ROUTER ISIS mode.
To view the IS-IS configuration, enter the
show isis protocol
command in EXEC Privilege mode or
the
show config
command in ROUTER ISIS mode.
Dell#show isis protocol
IS-IS Router: <Null Tag>
System Id: EEEE.EEEE.EEEE IS-Type: level-1-2
Manual area address(es):
47.0004.004d.0001
Routing for area address(es):
21.2223.2425.2627.2829.3031.3233
47.0004.004d.0001
Interfaces supported by IS-IS:
Vlan 2
TenGigabitEthernet 4/22
Loopback 0
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Dell#
Intermediate System to Intermediate System
539