Dell S4820T, Configuration Manual

Page: 421 / 1178

Application Name Port Number Client Server
FTP 20/21
Supported Supported
Syslog 514
Supported
Telnet 23
Supported Supported
TFTP 69
Supported
Radius 1812,1813
Supported
Tacacs 49
Supported
HTTP 80 for httpd
443 for secure httpd
8008 HTTP server port for confd application
8888 secure HTTP server port for confd
application
Supported
If you configure a source interface is for any EIS management application, EIS might not coexist with that
interface and the behavior is undefined in such a case. You can configure the source interface for the
following applications: FTP, ICMP (ping and traceroute utilities), NTP, RADIUS, TACACS, Telnet, TFTP,
syslog, and SNMP traps. Out of these applications, EIS can coexist with only syslog and SNMP traps
because these applications do not require a response after a packet is sent.
The switch also processes user-specified port numbers for applications such as RADIUS, TACACS, SSH,
and sFlow. The OS maintains a list of configured management applications and their port numbers. You
can configure two default routes, one configured on the management port and the other on the front-
end port.
Two tables, namely, Egress Interface Selection routing table and default routing table, are maintained. In
the preceding table, the columns Client and Server indicate that the applications can act as both a client
and a server within the switch. The Management Egress Interface Selection table contains all
management routes (connected, static and default route). The default routing table contains all
management routes (connected, static and default route) and all front-end port routes.
Enabling and Disabling Management Egress Interface Selection
You can enable or disable egress-interface-selection using the
management egress-interface-
selection
command.
NOTE: Egress Interface Selection (EIS) works only with IPv4 routing.
When the feature is enabled using the
management egress-interface-selection
command, the
following events are performed:
• The CLI prompt changes to the EIS mode.
• In this mode, you can run the
application
and
no application
commands
Internet Group Management Protocol (IGMP)
421