Dell S4820T, Configuration Manual

Page: 82 / 1178

Synchronizing Log Messages
You can configure Dell Networking OS to filter and consolidate the system messages for a specific line by
synchronizing the message output.
Only the messages with a severity at or below the set level appear. This feature works on the terminal and
console connections available on the system.
1. Enter LINE mode.
CONFIGURATION mode
line {console 0 | vty number [ end-number ] | aux 0}
Configure the following parameters for the virtual terminal lines:
•
number
: the range is from zero (0) to 8.
•
end-number
: the range is from 1 to 8.
You can configure multiple virtual terminals at one time by entering a number and an end-number .
2. Configure a level and set the maximum number of messages to print.
LINE mode
logging synchronous [level severity-level | all] [ limit ]
Configure the following optional parameters:
•
level severity-level
: the range is from 0 to 7. The default is 2 . Use the
all
keyword to
include all messages.
•
limit
: the range is from 20 to 300. The default is 20 .
To view the logging synchronous configuration, use the
show config
command in LINE mode.
Enabling Timestamp on Syslog Messages
By default, syslog messages do not include a time/date stamp stating when the error or message was
created.
To enable timestamp, use the following command.
• Add timestamp to syslog messages.
CONFIGURATION mode
service timestamps [log | debug] [datetime [localtime] [msec] [show-timezone]
| uptime]
Specify the following optional parameters:
– You can add the keyword
localtime
to include the
localtime
,
msec
, and
show-timezone
. If
you do not add the keyword
localtime
, the time is UTC.
–
uptime
: To view time since last boot.
If you do not specify a parameter, Dell Networking OS configures
uptime
.
82
Management