The default is
permit
.
The optional
seq
keyword allows you to assign a sequence number to the route map instance.
Configured Route Map Examples
The default action is
permit
and the default sequence number starts at
10
. When you use the keyword
deny
in configuring a route map, routes that meet the match filters are not redistributed.
To view the configuration, use the
show config
command in ROUTE-MAP mode.
Dell(config-route-map)#show config
!
route-map dilling permit 10
Dell(config-route-map)#
You can create multiple instances of this route map by using the
sequence number
option to place the
route maps in the correct order. Dell Networking OS processes the route maps with the lowest sequence
number first. When a configured route map is applied to a command, such as
redistribute
, traffic
passes through all instances of that route map until a match is found. The following is an example with
two instances of a route map.
The following example shows matching instances of a route-map.
Dell#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface TenGigabitEthernet 1/1
Set clauses:
tag 35
level stub-area
Dell#
To delete all instances of that route map, use the
no route-map
map-name
command. To delete just
one instance, add the sequence number to the command syntax.
Dell(conf)#no route-map zakho 10
Dell(conf)#end
Dell#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface TenGigabitEthernet 1/1
Set clauses:
tag 35
level stub-area
Dell#
The following example shows a route map with multiple instances. The
show config
command displays
only the configuration of the current route map instance. To view all instances of a specific route map,
use the
show route-map
command.
Dell#show route-map dilling
route-map dilling, permit, sequence 10
Match clauses:
Set clauses:
route-map dilling, permit, sequence 15
Match clauses:
interface Loopback 23
154
Access Control Lists (ACLs)
Summary of Contents for S4820T
