Distribute Routes
Another method of controlling routing information is to filter the information through a prefix list.
Prefix lists are applied to incoming or outgoing routes and routes must meet the conditions of the prefix
lists or Dell Networking OS does not install the route in the routing table. The prefix lists are globally
applied on all interfaces running IS-IS.
Configure the prefix list in PREFIX LIST mode prior to assigning it to the IS-IS process. For configuration
information on prefix lists, refer to
Applying IPv4 Routes
To apply prefix lists to incoming or outgoing IPv4 routes, use the following commands.
NOTE: These commands apply to IPv4 IS-IS only. To apply prefix lists to IPv6 routes, use ADDRESS-
FAMILY IPV6 mode, shown later.
• Apply a configured prefix list to all incoming IPv4 IS-IS routes.
ROUTER ISIS mode
distribute-list
prefix-list-name
in [
interface
]
Enter the type of interface and slot/port information:
– For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port
information.
– For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
– For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
– For a port channel interface, enter the keywords
port-channel
then a number.
– For a VLAN interface, enter the keyword
vlan
then a number from 1 to 4094.
• Apply a configured prefix list to all outgoing IPv4 IS-IS routes.
ROUTER ISIS mode
distribute-list
prefix-list-name
out [bgp
as-number
| connected | ospf
process-id
| rip | static]
You can configure one of the optional parameters:
–
connected
: for directly connected routes.
–
ospf
process-id
: for OSPF routes only.
–
rip
: for RIP routes only.
–
static
: for user-configured routes.
–
bgp
: for BGP routes only.
• Deny RTM download for pre-existing redistributed IPv4 routes.
ROUTER ISIS mode
distribute-list redistributed-override in
548
Intermediate System to Intermediate System
Summary of Contents for S4820T
