neighbor 172.30.1.250 no shutdown
5332332 9911991 65057 18508 12182 7018 46164 i
Configuring Peer Groups
To configure multiple BGP neighbors at one time, create and populate a BGP peer group.
An advantage of peer groups is that members of a peer group inherit the configuration properties of the
group and share same update policy.
A maximum of 256 peer groups are allowed on the system.
Create a peer group by assigning it a name, then adding members to the peer group. After you create a
peer group, you can configure route policies for it. For information about configuring route policies for a
peer group, refer to
.
NOTE:
for enabling peer groups are found at the end of this chapter.
1.
Create a peer group by assigning a name to it.
CONFIG-ROUTERBGP mode
neighbor
peer-group-name
peer-group
2.
Enable the peer group.
CONFIG-ROUTERBGP mode
neighbor
peer-group-name
no shutdown
By default, all peer groups are disabled.
3.
Create a BGP neighbor.
CONFIG-ROUTERBGP mode
neighbor
ip-address
remote-as
as-number
4.
Enable the neighbor.
CONFIG-ROUTERBGP mode
neighbor
ip-address
no shutdown
5.
Add an enabled neighbor to the peer group.
CONFIG-ROUTERBGP mode
neighbor
ip-address
peer-group
peer-group-name
6.
Add a neighbor as a remote AS.
CONFIG-ROUTERBGP mode
neighbor {
ip-address
|
peer-group name
} remote-as
as-number
Formats: IP Address A.B.C.D
•
Peer-Group Name
: 16 characters.
•
as-number
: the range is from 0 to 65535 (2-Byte) or 1 to 4294967295 | 0.1 to 65535.65535 (4-
Byte) or 0.1 to 65535.65535 (Dotted format)
222
Border Gateway Protocol IPv4 (BGPv4)
Summary of Contents for S4820T
