Dell S4820T, Configuration Manual

Page: 225 / 1178

When you enable fall-over, BGP tracks IP reachability to the peer remote address and the peer local
address. Whenever either address becomes unreachable (for example, no active route exists in the
routing table for peer IPv6 destinations/local address), BGP brings down the session with the peer.
The BGP fast fall-over feature is configured on a per-neighbor or peer-group basis and is disabled by
default.
To enable the BGP fast fall-over feature, use the following command.
To disable fast fall-over, use the
[no] neighbor [neighbor | peer-group] fall-over
command
in CONFIGURATION ROUTER BGP mode.
• Enable BGP Fast fall-Over.
CONFIG-ROUTER-BGP mode
neighbor { ip-address | peer-group-name } fall-over
Examples of Verifying that Fast fall-Over is Enabled on a BGP Neighbor and a Peer-Group
To verify that you enabled fast fall-over on a particular BGP neighbor, use the
show ip bgp neighbors
command. Because fast fall-over is disabled by default, it appears only if it has been enabled (shown in
bold).
Dell#sh ip bgp neighbors
BGP neighbor is 100.100.100.100, remote AS 65517, internal link
Member of peer-group test for session parameters
BGP version 4, remote router ID 30.30.30.5
BGP state ESTABLISHED, in this state for 00:19:15
Last read 00:00:15, last write 00:00:06
Hold time is 180, keepalive interval is 60 seconds
Received 52 messages, 0 notifications, 0 in queue
Sent 45 messages, 5 notifications, 0 in queue
Received 6 updates, Sent 0 updates
Route refresh request: received 0, sent 0
Minimum time between advertisement runs is 5 seconds
Minimum time before advertisements start is 0 seconds
Capabilities received from neighbor for IPv4 Unicast :
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
CISCO_ROUTE_REFRESH(128)
Capabilities advertised to neighbor for IPv4 Unicast :
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
CISCO_ROUTE_REFRESH(128)
fall-over enabled
Update source set to Loopback 0
Peer active in peer-group outbound optimization
For address family: IPv4 Unicast
BGP table version 52, neighbor version 52
4 accepted prefixes consume 16 bytes
Prefix advertised 0, denied 0, withdrawn 0
Connections established 6; dropped 5
Last reset 00:19:37, due to Reset by peer
Border Gateway Protocol IPv4 (BGPv4)
225