Dell S4820T, Configuration Manual

Page: 240 / 1178

Changing MED Attributes
By default, Dell Networking OS uses the MULTI_EXIT_DISC or MED attribute when comparing EBGP
paths from the same AS.
To change how the MED attribute is used, enter any or all of the following commands.
• Enable MED comparison in the paths from neighbors with different ASs.
CONFIG-ROUTER-BGP mode
bgp always-compare-med
By default, this comparison is not performed.
• Change the bestpath MED selection.
CONFIG-ROUTER-BGP mode
bgp bestpath med {confed | missing-as-best}
–
confed
: Chooses the bestpath MED comparison of paths learned from BGP confederations.
–
missing-as-best
: Treat a path missing an MED as the most preferred one.
To view the nondefault values, use the
show config
command in CONFIGURATION ROUTER BGP
mode.
Changing the LOCAL_PREFERENCE Attribute
In Dell Networking OS, you can change the value of the LOCAL_PREFERENCE attribute.
To change the default values of this attribute for all routes received by the router, use the following
command.
• Change the LOCAL_PREF value.
CONFIG-ROUTER-BGP mode
bgp default local-preference value
–
value
: the range is from 0 to 4294967295.
The default is 100 .
To view the BGP configuration, use the
show config
command in CONFIGURATION ROUTER BGP
mode or the
show running-config bgp
command in EXEC Privilege mode.
A more flexible method for manipulating the LOCAL_PREF attribute value is to use a route map.
1. Enter the ROUTE-MAP mode and assign a name to a route map.
CONFIGURATION mode
route-map map-name [permit | deny] [ sequence-number ]
2. Change LOCAL_PREF value for routes meeting the criteria of this route map.
CONFIG-ROUTE-MAP mode
set local-preference value
240
Border Gateway Protocol IPv4 (BGPv4)