seq 10 permit ip host 3.3.3.3 any
seq 15 redirect 2.2.2.2 ip any any
Create a Redirect List
To create a redirect list, use the following commands.
Create a redirect list by entering the list name.
CONFIGURATION mode
ip redirect-list
redirect-list-name
redirect-list-name
: 16 characters.
To delete the redirect list, use the
no ip redirect-list
command.
The following example creates a redirect list by the name of
xyz
.
Dell(conf)#ip redirect-list ?
WORD Redirect-list name (max 16 chars)
Dell(conf)#ip redirect-list xyz
Create a Rule for a Redirect-list
To set the rules for the redirect list, use the following command. You can enter the command multiple
times and create a sequence of redirect rules. Use the
seq
nn
redirect
version of the command to
organize your rules.
Configure a rule for the redirect list.
CONF-REDIRECT-LIST mode
seq
{number}
redirect {
ip-address | tunnel tunnel-id} [track <obj-id>
}{
ip-
protocol-number
|
protocol-type
[
bit
]} {
source mask
| any | host
ip-address
}
{
destination mask
| any | host
ip-address
}
•
number
is the number in sequence to initiate this rule
•
ip-address
is the Forwarding router’s address
•
tunnel
is used to configure the tunnel settings
•
tunnel-id
is used to redirect the traffic
•
track <obj-id>
is used to track the object-id
•
track
is to enable the tracking
• FORMAT: A.B.C.D
• FORMAT: slot/port
•
ip-protocol-number
or
protocol-type
is the type of protocol to be redirected
• FORMAT: 0-255 for IP protocol number, or enter protocol type
•
source ip-address
or
any
or
host
ip-address
is the Source’s IP address
• FORMAT: A.B.C.D/NN, or ANY or HOST IP address
Policy-based Routing (PBR)
731
Summary of Contents for S4820T
