To apply a Layer 2 policy on a Layer 3 interface:
1.
Configure an interface with an IP address or a VLAN sub-interface
CONFIGURATION mode
Dell(conf)# interface fo 1/4
INTERFACE mode
Dell(conf-if-fo-1/4)# ip address 90.1.1.1/16
2.
Configure a Layer 2 QoS policy with Layer 2 (Dot1p or source MAC-based) match criteria.
CONFIGURATION mode
Dell(conf)# policy-map-input l2p layer2
3.
Apply the Layer 2 policy on a Layer 3 interface.
INTERFACE mode
Dell(conf-if-fo-1/4)# service-policy input l2p layer2
Applying DSCP and VLAN Match Criteria on a Service Queue
You can configure Layer 3 class maps which contain both a Layer 3 Differentiated Services Code Point
(DSCP) and IP VLAN IDs as match criteria to filter incoming packets on a service queue on the switch.
To configure a Layer 3 class map to classify traffic according to both an IP VLAN ID and DSCP value, use
the
match ip vlan
vlan-id
command in class-map input configuration mode. You can include the
class map in a policy map, and apply the class and policy map to a service queue using the
service-
queue
command. In this way, the system applies the match criteria in a class map according to queue
priority (queue numbers closer to 0 have a lower priority).
To configure IP VLAN and DSCP match criteria in a Layer 3 class map, and apply the class and policy
maps to a service queue:
1.
Create a match-any or a match-all Layer 3 class map, depending on whether you want the packets
to meet all or any of the match criteria. By default, a Layer 3 class map is created if you do not enter
the
layer2
option with the class-map command. When you create a class map, you enter the class-
map configuration mode.
CONFIGURATION mode
Dell(conf)#class-map match-all pp_classmap
2.
Configure a DSCP value as a match criterion.
CLASS-MAP mode
Dell(conf-class-map)#match ipdscp 5
3.
Configure an IP VLAN ID as a match criterion.
CLASS-MAP mode
Dell(conf-class-map)#match ip vlan 5
4.
Create a QoS input policy.
CONFIGURATION mode
820
Quality of Service (QoS)
Summary of Contents for S4820T
