Dell S4820T, Configuration Manual

Page: 693 / 1178

Multi-Process OSPFv2 with VRF
Multi-process OSPF with VRF is supported on the Dell Networking OS.
Multi-process OSPF allows multiple OSPFv2 processes on a single router. Multiple OSPFv2 processes
allow for isolating routing domains, supporting multiple route policies and priorities in different domains,
and creating smaller domains for easier management.
The system supports up to 32 OSPFv2 processes.
Each OSPFv2 process has a unique process ID and must have an associated router ID. There must be an
equal number of interfaces and must be in Layer-3 mode for the number of processes created. For
example, if you create five OSPFv2 processes on a system, there must be at least five interfaces assigned
in Layer 3 mode.
Each OSPFv2 process is independent. If one process loses adjacency, the other processes continue to
function.
Processing SNMP and Sending SNMP Traps
Though there are may be several OSPFv2 processes, only one process can process simple network
management protocol (SNMP) requests and send SNMP traps.
NOTE: SNMP get request corresponding to the OspfNbrOption feild in the OspfNbrTable returns a
value of 66.
RFC-2328 Compliant OSPF Flooding
In OSPF, flooding is the most resource-consuming task. The flooding algorithm described in RFC 2328
requires that OSPF flood LSAs on all interfaces, as governed by LSA’s flooding scope (refer to Section 13
of the RFC.)
When multiple direct links connect two routers, the RFC 2328 flooding algorithm generates significant
redundant information across all links.
By default, Dell Networking OS implements an enhanced flooding procedure which dynamically and
intelligently detects when to optimize flooding. Wherever possible, the OSPF task attempts to reduce
flooding overhead by selectively flooding on a subset of the interfaces between two routers.
Enabling RFC-2328 Compliant OSPF Flooding
To enable OSPF flooding, use the following command.
When you enable this command, it configures Dell Networking OS to flood LSAs on all interfaces.
• Enable RFC 2328 flooding.
ROUTER OSPF mode
flood-2328
Example of Viewing the Debug Log for Flooding Behavior
To confirm RFC 2328 flooding behavior, use the
debug ip ospf packet
command. The following
example shows no change in the updated packets (shown in bold).
Open Shortest Path First (OSPFv2 and OSPFv3)
693