Dell Brocade DCX, Configuration Manual

Page: 178 / 1436

106 BigIron RX Series Configuration Guide
53-1001810-01
Configuring RADIUS security
4
NOTE
RADIUS command authorization can be performed only for commands entered from Telnet or SSH
sessions, or from the console. No authorization is performed for commands entered at the Web
Management Interface or
IronView Network Manager , .
NOTE
Since RADIUS command authorization relies on the command list supplied by the RADIUS server
during authentication, you cannot perform RADIUS authorization without RADIUS authentication.
Command authorization and accounting for console commands
The device supports command authorization and command accounting for CLI commands entered
at the console. To configure the device to perform command authorization and command
accounting for console commands, enter the following command.
BigIron RX(config)# enable aaa console
Syntax: [no] enable aaa console
CAUTION
If you have previously configured the device to perform command authorization using a RADIUS
server, entering the enable aaa console command may prevent the execution of any subsequent
commands entered on the console.
NOTE
This happens because RADIUS command authorization requires a list of allowable commands from
the RADIUS server. This list is obtained during RADIUS authentication. For console sessions, RADIUS
authentication is performed only if you have configured Enable authentication and specified RADIUS
as the authentication method (for example, with the aaa authentication enable default radius
command). If RADIUS authentication is never performed, the list of allowable commands is never
obtained from the RADIUS server. Consequently, there would be no allowable commands on the
console.
Configuring RADIUS accounting
The device supports RADIUS accounting for recording information about user activity and system
events. When you configure RADIUS accounting on device, information is sent to a RADIUS
accounting server when specified events occur, such as when a user logs into the device or the
system is rebooted.
Configuring RADIUS accounting for Telnet/SSH (Shell) access
To send an Accounting Start packet to the RADIUS accounting server when an authenticated user
establishes a Telnet or SSH session on the device, and an Accounting Stop packet when the user
logs out.
BigIron RX(config)# aaa accounting exec default start-stop radius
Syntax: aaa accounting exec default start-stop radius | | none