Dell Brocade DCX, Configuration Manual

Page: 1430 / 1436

1358 BigIron RX Series Configuration Guide
53-1001810-01
System parameters
E
logging enable user-login “Disabling the Syslog messages and traps” on
page 118
mac-age-time <age-time> “Changing the MAC age time” on page 132
multicast limit <number> “Configuring CLI banners” on page 124
route-only “Enabling or disabling Layer 2 switching” on
page 129
router bgp | dvmrp | ospf | pim | rip | vrrp | vrrpe “Enabling or disabling routing protocols” on page 126
show default values “Displaying and modifying system parameter default
settings”
on page 127
show logging “Examples of Syslog messages for CLI access” on
page 117
show sntp associations “Specifying a Simple Network Time Protocol (SNTP)
server”
on page 121
show sntp status “Specifying a Simple Network Time Protocol (SNTP)
server”
on page 121
show terminal “Checking the length of terminal displays” on
page 126
snmp-server contact <string> “Entering system administration information” on
page 114
snmp-server enable traps
<trap-type>
“Disabling SNMP traps” on page 116
snmp-server enable traps holddown-time <secs> “Setting the SNMP Trap holddown time” on page 116
snmp-server host <ip-addr> [0 | 1] <string> [port <value> ] “Specifying an SNMP trap receiver” on page 115
snmp-server location <string> “Entering system administration information” on
page 114
snmp-server trap-source loopback <num> | ethernet
<slot/port> | ve <num>
“Specifying a Single trap source” on page 115
sntp poll-interval <1-65535> “Specifying a Simple Network Time Protocol (SNTP)
server”
on page 121
sntp server <ip-addr> | <hostname> [ <version> ] “Specifying a Simple Network Time Protocol (SNTP)
server”
on page 121
static-mac-address <mac-addr> ethernet <portnum> [to
<portnum> ethernet <portnum> ]
[priority <number> ] [host-type | router-type | fixed-host]
“Assigning static MAC address entries to priority
queues” on page 470
system-max ip-static-route <num> “Displaying and modifying system parameter default
settings”
on page 127
system-max subnet-per-interface <num> “Displaying and modifying system parameter default
settings”
on page 127
system-max subnet-per-system <num> “Displaying and modifying system parameter default
settings”
on page 127
terminal length <number-of-lines> “Configuring terminal display” on page 126
unknown-unicast limit <number> “NP based multicast, broadcast, and
unknown-unicast rate limiting”
on page 503
Commands See ...