Dell Brocade DCX, Configuration Manual

Page: 251 / 1436

BigIron RX Series Configuration Guide 179
53-1001810-01
Configuring ARP parameters
7
Displaying IP receive access list
To determine if IP receive access list has been configured on the device, enter the following
command.
BigIron RX # show access-list bindings
L4 configuration:
ip receive access-list 101
Configuring ARP parameters
Address Resolution Protocol (ARP) is a standard IP protocol that enables the device to obtain the
MAC address of another device’s interface when the device knows the IP address of the interface.
ARP is enabled by default and cannot be disabled.
How ARP works
The device needs to know a destination’s MAC address when forwarding traffic, because the device
encapsulates the IP packet in a Layer 2 packet (MAC layer packet) and sends the Layer 2 packet to
a MAC interface on a device directly attached to the device. The device can be the packet’s final
destination or the next-hop router toward the destination.
The device encapsulates IP packets in Layer 2 packets regardless of whether the ultimate
destination is locally attached or is multiple router hops away. Since the device’s IP route table and
IP forwarding cache contain IP address information but not MAC address information, the device
cannot forward IP packets based solely on the information in the route table or forwarding cache.
The device needs to know the MAC address that corresponds with the IP address of either the
packet’s locally attached destination or the next-hop router that leads to the destination.
For example, to forward a packet whose destination is multiple router hops away, the device must
send the packet to the next-hop router toward its destination, or to a default route or default
network route if the IP route table does not contain a route to the packet’s destination. In each
case, the device must encapsulate the packet and address it to the MAC address of a locally
attached device, the next-hop router toward the IP packet’s destination.
To obtain the MAC address required for forwarding a datagram, the device does the following:
•
First, the device looks in the ARP cache (not the static ARP table) for an entry that lists the MAC
address for the IP address. The ARP cache maps IP addresses to MAC addresses. The cache
also lists the port attached to the device and, if the entry is dynamic, the age of the entry. A
dynamic ARP entry enters the cache when the device receives an ARP reply or receives an ARP
request (which contains the sender’s IP address and MAC address). A static entry enters the
ARP cache from the static ARP table (which is a separate table) when the interface for the
entry comes up.
To ensure the accuracy of the ARP cache, each dynamic entry has its own age timer. The timer
is reset to zero each time the device receives an ARP reply or ARP request containing the IP
address and MAC address of the entry. If a dynamic entry reaches its maximum allowable age,
the entry times out and the software removes the entry from the table. Static entries do not
age out and can be removed only by you.