Dell Brocade DCX, Configuration Manual

Page: 290 / 1436

218 BigIron RX Series Configuration Guide
53-1001810-01
Displaying IP information
7
This display shows the following information. The number in the left column of the CLI display is
the row number of the entry in the ARP cache. This number is not related to the number you assign
to static MAC address entries in the static ARP table.
Displaying the static ARP table
To display the static ARP table, enter the following command at any CLI level.
This example shows two static entries. Note that since you specify an entry’s index number when
you create the entry, it is possible for the range of index numbers to have gaps, as shown in this
example. The entry number you assign to a static ARP entry is not related to the entry numbers in
the ARP cache.
Syntax: show ip static-arp [ethernet <slot>/<portnum> | mac-address <xxxx.xxxx.xxxx> [<mask>]
|
<ip-addr> [<ip-mask>]] [<num>] [| begin <expression> | exclude <expression> | include
<expression>]
For information on the command syntax, refer to the syntax of the show arp command under
“Displaying the ARP cache” on page 217.
TABLE 51 CLI display of ARP cache
This field... Displays...
IP Address The IP address of the device.
MAC Address The MAC address of the device.
Type The type, which can be one of the following:
•
Dynamic – The device learned the entry from an incoming packet.
•
Static – The device loaded the entry from the static ARP table when the
device for the entry was connected to the device.
Age The number of minutes the entry has remained unused. If this value
reaches the ARP aging period, the entry is removed from the table.
To display the ARP aging period, refer to
“Displaying global IP configuration
information” on page 213. To change the ARP aging interval, refer to
“Changing the ARP aging period” on page 182.
NOTE: Static entries do not age out.
Port The port on which the entry was learned.
TABLE 52
CLI display of static ARP table
This field... Displays...
Static ARP table size The maximum number of static entries that can be configured on the device
using the current memory allocation. The range of valid memory allocations
for static ARP entries is listed after the current allocation. To change the
memory allocation for static ARP entries, refer to
“Changing the maximum
number of entries the static ARP table can hold” on page 184.
Index The number of this entry in the table. You specify the entry number when
you create the entry.
BigIron RX # show ip static-arp
Static ARP table size: 512, configurable from 512 to 1024
Index IP Address MAC Address Port
1 207.95.6.111 0800.093b.d210 1/1
3 207.95.6.123 0800.093b.d211 1/1