Dell Brocade DCX, Configuration Manual

Page: 741 / 1436

BigIron RX Series Configuration Guide 669
53-1001810-01
Configuring RIP parameters
24
•
Learning of standard RIP routes – By default, the device can learn RIP routes from all its RIP
neighbors. You can configure RIP neighbor filters to explicitly permit or deny learning from
specific neighbors.
Enabling learning of RIP default routes
By default, the device does not learn default RIP routes. You can enable learning of RIP default
routes on a global or interface basis.
To enable learning of default RIP routes on a global basis, enter the following command.
BigIron RX(config-rip-router)# learn-default
Syntax: [no] learn-default
To enable learning of default RIP routes on an interface, enter commands such as the following.
BigIron RX(config)# interface ethernet 1/1
BigIron RX(config-if-e10000-1/1)# ip rip learn-default
Syntax: [no] ip rip learn-default
Configuring a RIP neighbor filter
By default, a BigIron RX learns RIP routes from all its RIP neighbors. Neighbor filters allow you to
specify the neighbor routers from which the device can receive RIP routes. Neighbor filters apply
globally to all ports.
To configure a RIP neighbor filters, enter a command such as the following.
BigIron RX(config-rip-router)# neighbor 1 deny any
Syntax: [no] neighbor <filter-num> permit | deny <source-ip-address> | any
This command configures the device so that the device does not learn any RIP routes from any RIP
neighbors.
The following commands configure the device to learn routes from all neighbors except
192.168.1.170. Once you define a RIP neighbor filter, the default action changes from learning all
routes from all neighbors to denying all routes from all neighbors except the ones you explicitly
permit. Thus, to deny learning from a specific neighbor but allow all other neighbors, you must add
a filter that allows learning from all neighbors. Make sure you add the filter to permit all neighbors
as the last filter (the one with the highest filter number). Otherwise, the software can match on the
permit all filter before a filter that denies a specific neighbor, and learn routes from that neighbor.
BigIron RX(config-rip-router)# neighbor 2 deny 192.16.1.170
BigIron RX(config-rip-router)# neighbor 1024 permit any
Changing the route loop prevention method
RIP uses the following methods to prevent routing loops:
•
Split horizon – The device does not advertise a route on the same interface as the one on
which the router learned the route.
•
Poison reverse – The device assigns a cost of 16 (“infinite” or “unreachable”) to a route before
advertising it on the same interface as the one on which the router learned the route. This is
the default.