Dell Brocade DCX, Configuration Manual

Page: 1300 / 1436

1228 BigIron RX Series Configuration Guide
53-1001810-01
Displaying OSPFv3 information
48
This display shows the following information.
Displaying OSPFv3 neighbor information
You can display a summary of OSPFv3 neighbor information for the Brocade device or detailed
information about a specified neighbor.
To display a summary of OSPFv3 neighbor information for the device, enter the following command
at any CLI level.
Syntax: show ipv6 ospf neighbor [router-id < ipv4-address >]
The router-id < ipv4-address > parameter displays only the neighbor entries for the specified router.
This display shows the following information.
TABLE 209 OSPFv3 memory usage information
This field... Displays...
Total Static Memory
Allocated A summary of the amount of static memory allocated, in bytes, to OSPFv3.
Total Dynamic Memory
Allocated A summary of the amount of dynamic memory allocated, in bytes, to OSPFv3.
Memory Type The type of memory used by OSPFv3. (This information is for use by Brocade’s
technical support in case of a problem.)
Size The size of a memory type.
Allocated The amount of memory currently allocated to a memory type.
Max-alloc The maximum amount of memory that was allocated to a memory type.
Alloc-Fails The number of times an attempt to allocate memory to a memory type failed.
TABLE 210
Summary of OSPFv3 neighbor information
Field Description
Router ID The IPv4 address of the neighbor. By default, the Brocade router ID is the IPv4 address
configured on the lowest numbered loopback interface. If the device does not have a loopback
interface, the default router ID is the lowest numbered IPv4 address configured on the device.
Pri The OSPFv3 priority of the neighbor. The priority is used during election of the DR and BDR.
State The state between the Brocade device and the neighbor. The state can be one of the following:
•
Down
•
Attempt
•
Init
•
2-Way
•
ExStart
•
Exchange
•
Loading
•
Full
DR The router ID (IPv4 address) of the DR.
BigIron RX# show ipv6 ospf neighbor
RouterID Pri State DR BDR Interface[State]
1.1.1.1 1 Full 223.223.223.223 1.1.1.1 ethe 3/2 [DR]