Dell Brocade DCX, Configuration Manual

Page: 205 / 1436

BigIron RX Series Configuration Guide 133
53-1001810-01
Chapter
6
Configuring Interface Parameters
In this chapter
•
Assigning a port name . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 133
•
Assigning an IP address to a port. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 134
•
Speed/Duplex negotiation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 134
•
Disabling or re-enabling a port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 135
•
Changing the default Gigabit negotiation mode . . . . . . . . . . . . . . . . . . . . . 136
•
Disabling or re-enabling flow control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 136
•
Locking a port to restrict addresses. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 137
•
Wait for all cards feature. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 138
•
Port transition hold timer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 138
•
Modifying port priority (QoS) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 140
•
Assigning a mirror port and monitor ports. . . . . . . . . . . . . . . . . . . . . . . . . . 140
•
Monitoring an individual trunk port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 142
•
Mirror ports for Policy-Based Routing (PBR) traffic . . . . . . . . . . . . . . . . . . . 143
•
Displaying mirror and monitor port configuration . . . . . . . . . . . . . . . . . . . . 144
•
Enabling WAN PHY mode support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 144
Assigning a port name
NOTE
To modify Layer 2, Layer 3, or Layer 4 features on a port, refer to the appropriate section in this
chapter or other chapters. For example, to modify Spanning Tree Protocol (STP) parameters for a
port, refer to
“Changing STP port parameters” on page 322.
To configure trunk groups or dynamic link aggregation, refer to Chapter 8, “Link Aggregation” .
All device ports are pre-configured with default values that allow the device to be fully operational
at initial startup without any additional configuration. However, in some cases, changes to the port
parameters may be necessary to adjust to attached devices or other network requirements.
A port name can be assigned to help identify interfaces on the network. You can assign a port
name to physical ports, virtual routing interfaces, and loopback interfaces.
To assign a name to a port.
BigIron RX (config)# interface e 2/8
BigIron RX (config-if-e10000-2/8)# port-name Marsha Markey
Syntax: port-name <text>