Dell Brocade DCX, Configuration Manual

Page: 688 / 1436

616 BigIron RX Series Configuration Guide
53-1001810-01
Anycast RP
23
Displaying the RP set list
To display the RP set list, enter the following command at any CLI level.
Syntax: show ip pim rp-set
This display shows the following information.
Displaying multicast neighbor information
To display information about the device’s PIM neighbors, enter the following command at any CLI
level.
Syntax: show ip pim nbr
This display shows the following information.
Table 0.6:
This field... Displays...
Number of group prefixes The number f PIM Sparse group prefixes for which the RP is responsible.
Group prefix Indicates the multicast groups for which the RP listed by the previous
field is a candidate RP.
RPs expected/received Indicates how many RPs were expected and received in the latest
Bootstrap message.
RP <num> Indicates the RP number. If there are multiple RPs in the PIM Sparse
domain, a line of information for each of them is listed, and they are
numbered in ascending numerical order.
priority The RP priority of the candidate RP. During the election process, the
candidate RP with the highest priority is elected as the RP.
age The age (in seconds) of this RP-set.
NOTE: If this device is not a BSR, this field contains zero. Only the BSR
ages the RP-set.
BigIron RX(config)#show ip pim rp-set
Group address Static-RP-address Override
---------------------------------------------------
Access-List 44 99.99.99.5 On
Number of group prefixes Learnt from BSR: 1
Group prefix = 239.255.162.0/24 # RPs expected: 1
# RPs received: 1
RP 1: 43.43.43.1 priority=0 age=0
BigIron RX(config-pim-router)# show ip pim nbr
Port Neighbor Holdtime Age UpTime
sec sec sec
e3/8 207.95.8.10 180 60 900
Port Neighbor Holdtime Age UpTime
sec sec sec
v1 207.95.6.2 180 60 900