Dell Brocade DCX, Configuration Manual

Page: 747 / 1436

BigIron RX Series Configuration Guide 675
53-1001810-01
Chapter
25
Configuring OSPF Version 2 (IPv4)
In this chapter
•
Overview of OSPF (Open Shortest Path First) . . . . . . . . . . . . . . . . . . . . . . . 675
•
Configuring OSPF. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 681
•
Displaying OSPF information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 717
Overview of OSPF (Open Shortest Path First)
OSPF is a link-state routing protocol. The protocol uses link-state advertisements (LSA) to update
neighboring routers regarding its interfaces and information on those interfaces. The router floods
these LSAs to all neighboring routers to update them regarding the interfaces. Each router
maintains an identical database that describes its area topology to help a router determine the
shortest path between it and any neighboring router.
The device supports the following types of LSAs, which are described in RFC 2328 and 3101:
•
Router link
•
Network link
•
Summary link
•
Autonomous system (AS) summary link
•
AS external link
•
Not-So-Stubby Area (NSSA) external link
OSPF is built upon a hierarchy of network components. The highest level of the hierarchy is the
Autonomous System (AS) . An autonomous system is defined as a number of networks, all of which
share the same routing and administration characteristics.
An AS can be divided into multiple areas as shown in Figure 101 on page 676. Each area
represents a collection of contiguous networks and hosts. Areas limit the area to which link-state
advertisements are broadcast, thereby limiting the amount of flooding that occurs within the
network. An area is represented in OSPF by either an IP address or a number.
You can further limit the broadcast area of flooding by defining an area range. The area range
allows you to assign an aggregate value to a range of IP addresses. This aggregate value becomes
the address that is advertised instead all of the individual addresses it represents being
advertised. You can assign up to 32 ranges in an OSPF area.
An OSPF router can be a member of multiple areas. Routers with membership in multiple areas
are known as
Area Border Routers (ABRs) . Each ABR maintains a separate topological database
for each area the router is in. Each topological database contains all of the LSA databases for each
router within a given area. The routers within the same area have identical topological databases.
The ABR is responsible for forwarding routing information or changes between its border areas.