Dell Brocade DCX, Configuration Manual, Page: 104 / 1436

32 BigIron RX Series Configuration Guide
53-1001810-01
Managing management module redundancy
3
File synchronization between the active and standby management
modules
Each active and standby management module contains the following files that can be synchronized
between the two modules are:
•
Flash code – The flash code can include the following files:
•
monitor, which contains the management module’s Real Time Operating System (RTOS).
•
primary, which contains the management module’s primary RX Series IronWare image.
•
secondary, which contains the management module’s secondary RX Series IronWare
image.
A RX Series IronWare image contains the layer 1 – 3 software run by the management module.
During startup or switchover, the active module compares the standby module’s flash code to
its own. If differences exist, the active module synchronizes the standby module’s flash code
with its own. If you update the flash code on the active module, the active module
automatically synchronizes (without comparison) the standby module’s flash code with its own.
•
System-config file – The flash code also includes the system-config file. During startup or
switchover, the active module compares the standby module’s system-config file to its own. If
differences exist, the active module synchronizes the standby module’s system-config file with
its own. When you save changes to the system-config file on the active module, the active
module automatically synchronizes (without comparison) the standby module’s system-config
file with its own.
•
Running-config – The running-config file resides in the BigIron RX Series system’s memory. The
running-config file is automatically synchronized (without comparison) from the active module
to the standby module at regular intervals. The default interval is 7 seconds.
Each active and standby management module also includes boot code, which is the code a module
runs when it first starts up. The boot code resides in each module’s boot flash. The boot code is not
synchronized between the two modules. The unsynchronized boot code allows the system to run
using an older version of boot code on the standby module if desired.
NOTE
Whenever you load a new card into a chassis, check the card to ensure that it has the appropriate
boot code revision. If the boot code is from a previous version, then upgrade the code.