Dell Brocade DCX, Configuration Manual, Page: 1306 / 1436

1234 BigIron RX Series Configuration Guide
53-1001810-01
Displaying OSPFv3 information
48
The area < area-id > parameter specifies a particular area. You can specify the <area-id> in the
following formats:
•
As an IPv4 address; for example, 192.168.1.1
•
As a numerical value from 0 – 2,147,483,647
This display shows the following information.
For example, to display the SPF table for area 0, enter the following command at any level of the
CLI.
Syntax: show ipv6 ospf spf table area < area-id >
The table parameter displays the SPF table.
The area < area-id > parameter specifies a particular area. You can specify the < area-id > in the
following formats:
•
As an IPv4 address, for example, 192.168.1.1
•
As a numerical value from 0 – 2,147,483,647
TABLE 214 OSPFv3 SPF node information
This field... Displays...
SPF node Each SPF node is identified by its router ID (IPv4 address). If the node is a child node,
it is additionally identified by an interface on which the node can be reached
appended to the router ID in the format <
router-id >:< interface-id >.
Cost The cost of traversing the SPF node to reach the destination.
Hops The number of hops needed to reach the parent SPF node.
Next Hops to Node The IPv6 address of the next hop-router or the router interface through which to
access the next-hop router.
Parent Nodes The SPF node’s parent nodes. A parent node is an SPF node at the highest level of the
SPF tree, which is identified by its router ID.
Child Nodes The SPF node’s child nodes. A child node is an SPF node at a lower level of the SPF
tree, which is identified by its router ID and interface on which the node can be
reached.
BigIron RX# show ipv6 ospf spf table area 0
SPF table for Area 0
Destination Bits Options Cost Nexthop Interface
R 1.1.1.1 ---- V6E---R- 1 fe80::2e0:52ff:fe91:bb37 ethe 3/2
N 223.223.223.223[88] ---- V6E---R- 1 :: ethe 3/2