Dell Brocade DCX, Configuration Manual

Page: 501 / 1436

BigIron RX Series Configuration Guide 429
53-1001810-01
Displaying VSRP information
15
There are no CLI commands used to configure this process.
Displaying VSRP information
You can display the following VSRP information:
•
Configuration information and current parameter values for a VRID or VLAN
•
The interfaces on a VSRP-aware device that are active for the VRID
Displaying VRID information
To display detailed VSRP information, enter the show vsrp vrid or show vsrp vlan command. Both
commands show the same information as in the following example.
Syntax: show vsrp [vrid <num> | vlan <vlan-id> ]
This display shows the following information when you use the vrid <num> or vlan <vlan-id>
parameter. For information about the display when you use the aware parameter, refer to
“Displaying the active interfaces for a VRID” on page 433.
TABLE 81 CLI display of VSRP VRID or VLAN information
This field... Displays...
Total number of VSRP routers defined The total number of VRIDs configured on this device.
VLAN The VLAN on which VSRP is configured.
auth-type The authentication type in effect on the ports in the VSRP VLAN.
VRID parameters
VRID The VRID for which the following information is displayed.
BigIron RX# show vsrp vrid 100
VLAN 10
Auth-type no authentication
VRID 10
========
State Administrative-status Advertise-backup Preempt-mode
Master Enabled Disabled True
Parameter Configured Current Unit/Formula
Priority 100 80 (100-0)*(4.0/5.0)
Hello-interval 1 1 sec/10
Dead-interval 3 3 sec/10
Hold-interval 3 3 sec/10
Initial-ttl 2 2 hops
Backup-Hello 60 60 sec/10
Next hello sent in 00:00:01
Member ports: ethe 3/1 ethe 3/3 ethe 6/1 ethe 11/1 ethe 14/1
Operational ports: ethe 3/1 ethe 3/3 ethe 6/1 ethe 14/1
Forwarding ports: ethe 3/1 ethe 3/3 ethe 6/1 ethe 14/1
Restart ports: 3/1(10) 3/3(10) 6/1(10) 11/1(10) 14/1(10)