Dell Brocade DCX, Configuration Manual

Page: 934 / 1436

862 BigIron RX Series Configuration Guide
53-1001810-01
Displaying MBGP information
27
The following sections show examples of some of the MBGP show commands. An example of the
show ip mroute command is also included. This command displays the IP multicast route table.
Displaying summary MBGP information
To display summary MBGP information, enter the following command at any CLI prompt.
Syntax: show ip mbgp summary
NOTE
This command’s display looks similar to the display for the show ip bgp config command. However,
the show ip mbgp config command lists only the MBGP neighbors, whereas the show ip bgp config
command lists only the BGP neighbors.
show ip mbgp <ip-addr> [/ <prefix> ] Displays a specific MBGP route.
show ip mbgp attribute-entries Displays MBGP route attributes.
show ip mbgp dampened-paths Displays MBGP paths that have been dampened by route flap
dampening.
show ip mbgp flap-statistics Displays route flap dampening statistics.
show ip mbgp filtered-routes Displays routes that have been filtered out.
TABLE 128 MBGP Show commands (Continued)
Command Description
BigIron RX# show ip mbgp summary
BGP4 Summary
Router ID: 9.9.9.1 Local AS Number : 200
Confederation Identifier : not configured
Confederation Peers:
Maximum Number of Paths Supported for Load Sharing : 1
Number of Neighbors Configured : 1, UP: 1
Number of Routes Installed : 5677
Number of Routes Advertising to All Neighbors : 5673
Number of Attribute Entries Installed : 3
Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend
166.1.1.2 200 ESTAB 0h24m54s 3 0 5673 0